Kong ORTLES Instructions D'utilisation Et D'entretien page 12

Pass the rope under the winch (picture 18) and wind it up clockwise (alt least 4 turns) around
the drum, then pass it on the arm and insert it in the self-tailing.
The rope must make a complete turn in it.
After winding up the rope on the Ortles insert the hand levers in the winch by operating the little
lever on the upper end of the shaft to mate the safety board.
Insert and then release the locking lever (picture 20).
FIG. 20
Now you can begin the recovery operation. When the rope is stretched it will coil on the
winch.
While a rescuer guides and slightly stretches the rope coming out of the self-tailing and sends
it back in the rest plate tab through a snaplink (picture 21) making sure it does not tangle nor is
trampled on, one or more operators operate the hand lever for the rescue.
KONG s.p.a. KONG s.p.a. Zona Industriale - Zona Industriale -
TEL. + 39 0341 630506 • FAX. + 39 0341 641550 • EMAIL: kong@kong.it • WEB SITE: http://www.kong.it TEL. + 39 0341 630506 • FAX. + 39 0341 641550 • EMAIL: kong@kong.it • WEB SITE: http://www.kong.it
FIG. 18
LOCKING LEVER
via XXV Aprile, 4 - 23804 MONTE MARENZO (LC) - ITALY via XXV Aprile, 4 - 23804 MONTE MARENZO (LC) - ITALY
SELF-TAILING
ARM
FIG. 19
FIG. 21
9