Kong ORTLES Instructions D'utilisation Et D'entretien page 15

PASSING OF THE KNOT DURING THE DROPPING
Let the rope slide until the knot passes through the operator's hands and begins to turn
on the drum.
Just before the knot comes to the ascender called "A" at about 10 cm (picture 28) release the
safety cable and lock the rope stopping the dropping.
Now position the second ascender called "B" (picture 29), with snaplinks and tape (supplied)
to be hooked in one of the plate holes. This ascender must be placed on the rope at about
10 cm over the ascender "A" (picture 29).
ASCENDER
"A"
KONG s.p.a. KONG s.p.a. Zona Industriale - Zona Industriale -
TEL. + 39 0341 630506 • FAX. + 39 0341 641550 • EMAIL: kong@kong.it • WEB SITE: http://www.kong.it TEL. + 39 0341 630506 • FAX. + 39 0341 641550 • EMAIL: kong@kong.it • WEB SITE: http://www.kong.it
10 cm
FIG. 28
FIG. 30
via XXV Aprile, 4 - 23804 MONTE MARENZO (LC) - ITALY via XXV Aprile, 4 - 23804 MONTE MARENZO (LC) - ITALY
ASCENDER
"B"
Hold the rope tight by the hands, regain one
or two centimetres rope through the hand
lever to release the ascender "A" and open
it wide (picture 30).
10 cm
FIG. 29
12