Installation Recommendations - Niko 05-715 Mode D'emploi

05-715

Installation recommendations:

- If you install several modules next to each other, maintain a
distance of min. 1 module with suitable blank plates.
- Preferably place the dimmers at the bottom of the distribution
board.
- Check the temperature. If the temperature in the distribution
board rises too high (max. 35°C), provide additional ventilation.
Provide sufficient space at the top of the board. Place a ventilator
if necessary.
3. PROGRAMMING
A. Select operating mode
The dimmer is programmed in control mode 0-10V as a
standard.
You can modify the operating mode. Enter the dimmer's
programming mode: press the select button for >3s.
- the load switches off
- the input LED 0-10V blinks.
> 3s
To modify the operating mode, briefly press the select button
repeatedly. The operating mode is indicated by a blinking input
LED.
Note: if you select 2-button mode, all LEDs blink.
EN 57