Installation Recommendations - Niko 05-353 Mode D'emploi

05-353
If everything has been connected correctly and the power is
switched on, the load LED and the error indication LED light
simultaneously for 1s. If no load is connected, both LEDs blink.
A connected load can manually be switched on and off by means
of the select button.

Installation recommendations:

- If you install several modules next to each other, maintain a
distance of min. 1 module with suitable blank plates.
- Preferably place the dimmers at the bottom of the distribution
board.
- Check the temperature. If the temperature in the distribution
board rises too high (max. 35°C), provide additional ventilation.
Provide sufficient space at the top of the board. Place a ventilator
if necessary.
3. PROGRAMMING
A. Select operating mode
To change the operating mode, briefly press the 'select' button.
You can easily recognise the mode you want to select by the
beep signal (1Hz short pulse).
1x short beep for 1-push button operation with/without memory;
2x short beep for 2-push button operation with/without memory;
3x short beep for calling up/programming a light atmosphere;
4x short beep for OFF with 3-second operating time;
5x short beep for OFF with time delay (run time).
EN 55