Hendi 224328 Mode D'emploi page 12

VOLTAGE LACKING
In case of electric feeding breaking or if the machine
is disconnected from the electric net, this last one
will be able to be restarted only following the star-
CONTROLS AND VERIFICATIONS BEFORE STARTING
VERIFICATION / CONTROL
Check that:
• There aren't inside the pot
extraneous objects
Check the cleaning:
• Of the machine external sides
• of the tool along its surface
• of the tool external sides
Check the integrity:
• of the fixed protections
• of the machine body
Check the functionality:
• of the control system
parts / control about the
EN
safety;
• of the control devices.
Check the absence:
• of strange noises after
the starting
For any intervention type or for the parts change that
are damaged, activate the maintenance service.
The possible change must happen with manufactur-
PUT IN FUNCTION
The machine operator can put in function the machi-
ne following in order the under reported indications:
• Positive controls result for the preparation pre-
liminary operations,
• Positive controls result for the electric feeding,
• Plug connection in opportune current socket,
• Positive controls result for the assembly,
• Positive controls result / checks before the starting,
• Positive controls result finalized to check the re-
spect of all safety conditions,
• Introduce manually the feed product inside the pot,
12
MODALITIES AND CHECKS
Sight control of the indicated parts, to check of objects or extraneous bodies
lacking as for example different tools, clothes, etc ... and that there isn't however
the food product
All indicated parts surfaces, before the machine use must be checked visually to
verify their cleaning. In case of molds presence or other type of dirtiness, provide
with the cleaning procedure in accordance with the chapter 5 indications.
All fixed protections, etc.. must perform the function for which have been
foreseen. Indicated parts sight check to verify their integrity in their surface
external part. The parts must be however changed at the first erosion signals or
breaking (cfr. Authorized Assistance Center).
All devices must perform the function for which have been foreseen. Control
directly the devices so that these ones determine the waiting function.
The actuators and all parts must be however changed to the first erosion signals
or breaking (cfr. Authorized Assistance Center).
During the functionality checking of the control devices, if there are strange
noises, due for example to a seizing or mechanical breaks, stop immediately the
machine and activate the maintenance service.
ting function, after the electric feeding back or the
reconnection to the electric net.
er original products or at least of quality, safety and
equivalent characteristics. For analysis contact the
Authorized Assistance Center.
• With the use of both the hands take the machine
in the foreseen zones:
– Place it with the tool inside the pot,
– Start, maintain and handle it up to the end of the
feed product work,
• When the food product has reached the desired
solidity, stop the machine and placed on a support
adequate bench,
• Discharge manually the pot feed product, taking it
with both the hands and pouring out the feed
product where necessary.