Playing Using A Timer (Cdp-Ca9Es Only) - Sony CDP-CA9ES Mode D'emploi

Playing CDs
You can create your programme while checking the
disc labels
While the disc tray is open, follow Steps 1 to 5 with
pressing DISC SKIP to check the disc labels. If you close
the disc tray before Step 5, the total playing time appears
in the display after a while.
Note that, if the programmed track number isn't found
on the disc, that step is automatically erased.
The programme remains even after the Programme
Play ends
When you press (, you can play the same programme
again.
The programme remains until you erase it
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren't found in the player or on the disc are
deleted from the programme, and the rest of the
programme is played in the programmed order.
EN
Note
12
The total playing time doesn't appear when:
—You have programmed a track whose number exceeds 20.
—The total playing time of the programme exceeds 200
minutes.
Checking the track order
You can check your programme before or after you
start playing.
Press CHECK on the remote.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
"AL" appears instead of the track number.) After the
last step in the programme, the display shows
"–END–" and returns to the original display. If you
check the order after you start playing, the display
shows only the remaining steps.
Changing the track order
You can change your programme before you start
playing.
To You need to
Erase a step Press CHECK until the track or disc
you don't want appears in the
display, then press CLEAR
Erase the last step in Press CLEAR. Each time you press
the programme the button, the last track or disc will
be cleared.
Add steps to the end Follow Steps 2 to 4 in "Creating Your
of the programme Own Programme" on page 11
Change the whole Hold down CLEAR until "ALL
programme CLEAR" appears in the display to
completely erase the whole programme, then
create a new programme following
Steps 2 to 4 in "Creating Your Own
Programme" on page 11
Playing Using a Timer
(CDP-CA9ES only)
You can start playing a disc at any time you want by
connecting a timer (not supplied). Please also refer to
the instructions for the timer if you need help.
TIMER
1
Press one of the play mode buttons to select the
play mode you want.
2
Set TIMER on the player to PLAY.
3
Set the timer to the time you want.
The player turns off. When the set time comes, the
player turns on and starts playing.
4
After you have used the timer, set TIMER on the
player to OFF.
Play mode buttons