Festo ADN-KP Série Notice D'utilisation page 23

KP/KPE/ADN−...−KP/DNC−...−KP/DS NU−...−KP
Pneumatic components
Connecting the tubing for the clamping
cartridge/clamping unit:
1. Remove the screw on compressed air con
nection 2 of the clamping cartridge.
2. Insert a screw connector into the com
pressed air connection 2 of the clamping
cartridge.
The tightening torque is 0.5 Nm.
Connecting the tubing of the cylinder with clamping unit:
Connect the tubing of the clamping cartridge and the cylinder with the direc
S
tional control valves intended for this purpose.
Two control examples are given below.
Clamping when there is a sudden
pressure failure
Fig. 15
Festo KP/KPE/ADN−...−KP/DNC−...−KP/DSNU−...−KP 0703d
English
Fig. 14
Moving to any desired position and
clamping
2
23