Help - TRACE ELLIOT AH1000-12 Guide D'utilisation

HELP

If you experience problems with your Trace Elliot unit please check the following before contacting
an authorised Trace Elliot dealer, distributor or service centre.
Symptom
Unit does not power up
Unit powers up but no sound
Signal level LEDs do not light
Signal level LEDs light but no sound
No signal when LOOP selected (12 Band)
Unwanted distorted signal
General purpose protection LED on
Is it overheating?
Check
IEC mains cord is correctly connected.
Fuse in IEC inlet is OK.
Fuse in IEC mains cord is OK.
All connecting leads.
Instrument leads and battery if applicable.
OUTPUT LEVEL is turned above '1'.
Is MUTE or LOOP selected? If so,
turn off.
Leads in Effects Loop (7 Band).
Is it set SERIES? Set to PARALLEL.
LOOP LEVEL is turned up.
Connecting leads in LOOP.
External devices used in LOOP.
Is INPUT GAIN set correctly? Reset.
Is GRAPHIC set too extreme?
Is battery in instrument OK?
Check Speaker wiring.
Ensure vents are clear.
24