Front Panel Brightness Rotary Control; Power Switch; Iec Socket And Fuse Holder - TRACE ELLIOT AH1000-12 Guide D'utilisation

(34) FRONT PANEL BRIGHTNESS rotary control

This literally controls the brightness of the back lighting on the front panel. Fully anti-clockwise
will turn it completely off. This does not affect the brightness of the small status LEDs.
The back lighting is produced by state of the art, high powered LEDs positioned behind the Perspex
(plexi-glass) part of the front panel and gives the familiar green glow of Trace Elliot amplifiers on
stage. LEDs have been used as they do not produce any electronic noise or hum that could be
detrimental to the sound.
The control has been included to enable users to set the BRIGHTNESS to their taste and also to turn
the back lighting off completely in situations where it would be undesirable.

(35) POWER switch

Once the whole system has been set up, set this to the ON or "1" position to apply mains power.
The switch will be illuminated green when the unit is on. Switch to the OFF or "0" position at the
end of normal use before any of the system is disconnected.

(36) IEC socket and fuse holder

This is to connect the supplied IEC mains power cord. The mains voltage that the specific unit is
built to accept is marked on the rear panel. Before applying mains power please ensure that it is the
correct voltage.
For your safety we recommend that you use the mains cord provided. Other mains cords may
contain lower value fuses that could blow at high volume and shut down the amplifier thereby
spoiling a performance.
The fuse tray within the IEC socket contains the mains fuse. If replaced it must be with the same
type and rating as marked on the rear panel. Failure to do so may render the unit unsafe and
invalidate the warranty. If the fuse repeatedly blows then consult your authorised Trace Elliot
dealer, or a qualified service engineer.
21