EdilKamin FANTASY Installation page 37

Commissioning must be done by a Technical Service Centre
authorised by Edilkamin (CAT) prior to ignition and testing
according to the UNI 10683/2012 standard.
This standard indicates the control operations to be carried out
in situ, aimed at ascertaining correct system function.
Before igniting.
Edilkamin technical service centre (CAT), (for information
see the www.edilkamin.com website) to calibrate the stove
according to the type of pellets used and installation conditions,
thereby starting the guarantee.
Failure to have the stove ignited by an authorised C.A.T. pre-
vents Edilkamin from guaranteeing correct functioning.
here may be a slight smell of paint the rst few times it is
ignited, however, this will disappear quic ly.
efore igniting you must chec :
that installation is correct
the power supply
that the door closes properly to a perfect seal
that the combustion chamber is clean
that the display is on standby (the date, power or temperature
ashes).
FILLING THE PELLET HOPPER
he hopper lid opens and closes with a practical clic -clac
system. Simply apply slight pressure to the front part of the
cast iron lid ( g. ).
ATTENTION:
use the glove supplied when lling the stove whilst it is run-
ning and therefore is hot.
NOTE regarding the fuel.
he stoves is designed and programmed to burn wood pellets
with mm diameter.
ellets are a type of fuel in the form of little cylinders, made
from compacted sawdust, compressed under high pressure
with no adhesives or foreign materials.
hey are sold in bags of
For the stove to function properly, you
anything else in it. sing other materials (including wood)
will render the warranty null and void. Such use is detected by
laboratory analyses. Edil amin has designed, tested and pro-
grammed their stoves to guarantee the best performance when
pellets with the following characteristics are used:
dia eter: 6 illi etres
axi u length:
axi u oisture content:
calori c value: at least
INSTRUCTIONS FOR USE
g.
S burn
cal g.
g.
f pellets with different characteristics are used, the stoves
must be recalibrated a similar procedure to that carried out by
the E LER when the stove is ignited the rst time.
sing unsuitable pellets may: decrease ef ciency; cause
malfunctions; stop the stove from functioning due to clogging,
dirt on the glass, unburnt fuel, etc.
simple, visual analysis of the pellets may be carried out:
Good uality: smooth, uniform length, not very dusty.
Poor uality: with longitudinal and transverse crac s, very
dusty, various lengths and mi ed with foreign matter.
- 37
-