Keypad Programming - Nice MORX Mode D'emploi

Table "A1" Using the Keypad (users)
1. Enter the combination
2. Press the key to activate the output
While entering the combination, no more than 10 seconds must
elapse between pressing one key and pressing the next; after this
delay the combination must be entered again from the start.
Each combination may activate just one or both outputs.
in the first case, enter it and press the corresponding confirmation key only
(e.g.: is only valid for output
case, press either of the two confirmation keys (e.g.:
output and output ).

5.2) KEYPAD programming

This part analyses the access control system programming
procedures when KEYPADS are used.
In the KEYPAD mode, the two output relays are associated with the
confirmation keys and
14
and not for output ). in the second
is valid both for
.
In the EASY mode, a single combination can be given to all
users, or one for just output
In the PROFESSIONAL mode, each user or group of users
can be given their own combination in order to make it easy to
add or remove users.
Key is confirmation for the relay 1 output
Key is confirmation for the relay 2 output
In the PROFESSIONAL mode, key
during programming phases.
In the PROFESSIONAL mode, key
programming phase.
Example
1234
or
and another for just output .
is also used for "confirmation"
is also used for "cancelling" the