Changing Between Celsius And Fahrenheit; How To Recall 12 Readings In Memory Mode; Error Messages - Microlife FR 100 Mode D'emploi

4. Place the measuring sensor gently at the center of the
forehead. Please remove any hair, sweat or dirt from the
forehead before measuring to improve the accuracy of
the readings.
5. Press the START button 2 once and release it. A long
beep sound will emit after 3 seconds to acknowledge the
completion of measurement.
6. Read the recorded temperature from the LCD display.

NOTE:
 Patients and thermometer should stay in similar
room condition for at least 30 minutes.
 Don't take a measurement while or immediately after
nursing a baby.
 Don't use the forehead thermometer in high humidity
environments.
 Patients should not drink, eat or exercise before/while
taking the measurement.
 Before placing the thermometer probe onto the
measurement area, remove dirt, hair, or sweat.
 Don't move the measurement device from the measuring
area before hearing the termination beep.
 Use an alcohol swab to carefully clean the probe and wait
for 15 minutes before taking a measurement on another
patient.
FR 100
 10 short beeps and a red LCD backlight alert the patient
that he/she may have a temperature equal to or higher
than 37.5 °C.
 Always take the temperature in the same location, since
temperature readings may vary according to locations.
 In the following situations it is recommended that three
temperatures are taken with the highest one taken as
the reading:
1. New born infants in the first 100 days.
2. Children under three years of age with a compro-
mised immune system and for whom the presence or
absence of fever is critical.
3. When the user is learning how to use the thermometer
for the first time until he/she has familiarized himself/
herself with the device and obtains consistent readings.
4. If the measurement is surprisingly low.

6. Changing between Celsius and Fahrenheit

This thermometer can display temperature readings in either
Fahrenheit or Celsius. To switch the display between °C and
°F, simply turn OFF the unit, press and hold the START
button 2 for 5 seconds; after 5 seconds, the current
measurement scale («°C» or «°F» icon) will flash on the
display AK. Change the measurement scale between °C and
°F by pressing the START button 2. When the measure-
ment scale has been chosen, wait for 5 seconds and the unit
will automatically enter the «ready for measuring» mode.

7. How to recall 12 readings in Memory Mode

This thermometer can recall the last 12 readings.
 Recall mode AL: Press the START button 2 to enter
Recall mode when power is off. The memory icon «M»
will flash.
 Reading 1 - the last reading AM: Press and release the
START button 2 to recall the last reading. Display 1
alone with memory icon.
 Reading 12 - readings in succession: Press and
release the START button 2 consecutively to recall the
last 12 readings in succession.
Pressing and releasing the START button 2 after the last
12 readings have been recalled will resume the above
sequence from reading 1.

8. Error Messages

 Measured temperature too high AN: Displays «H» when
measured temperature higher than 42.2 °C / 108.0 °F.
 Measured temperature too low AO: Displays «L» when
measured temperature lower than 34.0 °C / 93.2 °F.
5 EN