Electric System; With John Deere Engine - GOLDONI STAR Manuel D'emploi Et Entretien

6.9 ELECTRIC SYSTEM

- Battery
Check electrolyte level and keep it topped up so that the battery elements are
always covered. Add distilled water with the engine switched off and with no
naked flames nearby. Check battery clamp fixing performance and keep the
terminals greased with Vaseline. Keep the battery clean and if the tractor has to
be inactive for a long time, remove the battery and store it in a cool dry place.
- Clogging gauge of the engine air filter
Check that the clogging gauge of the engine air filter is in the correct position
and, if it is serviced, make sure that it is correctly assembled and protected
against the outdoor weather conditions as indicated in fig.3.
It is essential for the cable connecting to the electrical system of the machine N°
1 fig.3 to come out of the lower part of the actual gauge itself. The engine air
intake circuit could be seriously damaged if the protection is installed in the
wrong position.

6.9.1 With John Deere engine

Fuses:
A = 10A = Rear right - front left side lights, rh licence plate light, 7-pin socket,
side light,
Indicator light
B = 10A = Rear left - front right side lights, lh licence plate light, 7-pin socket
C= 15A = Power supply for 4WD switch, +15 turn indicator emergency switch
(hazard lights, parking brake switch
D = 10A = 4WD relay enabling relay power supply
E = 10A = Rh dipped beam
F = 10A = Lh dipped beam
G = 7,5A =Power supply for differential lock switch, optional powering connector
H = 7,5A = Power supply for motor stop solenoid, ECX alternator
I = 15A = Rh and lh driving beams, turn indicator switch, driving beam Indicator
light
L = 15A = Power supply for +30 turn indicator emergency switch (hazard lights),
1-pin
Socket, driving beam blinker
M = 10A = Power supply for 7-pin socket, light switch
N = 20A = 1-pin socket power supply
94