Publicité
Pull webbing
through bridle
loop
Bridle loop
6) Two people are recommended for attaching the springs. Place black jump mat with warning
label facing upward in the center of the SuperTramp™. Work across from each other, placing
a spring from the metal triangle on the jump mat first, and then pulling toward the correspond-
ing slot in the frame bar. Always start at the middle triangle and stretch the spring to the corre-
sponding middle slot in the frame bar. USE SPRING HOOK AND/OR GLOVES TO PROTECT
YOUR HANDS FROM PINCHING DURING ASSEMBLY.
7) Once you have placed the first two springs opposite each other, consider this position 1
and 2. Now locate position 3 and 4 and repeat the same instructions. The jump mat is now
supported by the 4 springs. Again, working across from each other, place the remaining
springs into the triangles on the jump mat and pull them into the slots on the frame bar until all
springs are connected.
8) Next, unfold the white spring pad cover and place it over the springs and frame until they
are all covered. Line up the spring pad cover to match the octagonal shape of the tube and
frame. Reach underneath the spring pad cover in all 8 corners. Feed the webbing strap under
3
7
2
6
the bottom of the frame bar, then through the buckle. Secure the spring pad cover to the
frame in each corner. Cinch each strap to ensure a snug fit.
9) Roll out your Swimstep™ access platform and connect it to the SuperTramp™ BEFORE
INFLATING the platform using the attached Interloc™ straps. The access platform connects
on the side of the trampoline where the warnings are located. Find the D-rings on the tube
near the water line. Take the (2) Interloc™ straps and connect the access platform to the
tube. Secure the straps. Once the straps are connected, inflate the boarding platform until it
is firm. This will tighten the platform to the side of the SuperTramp™. Be careful not to over
inflate the access platform.
10) You are now ready to place your SuperTramp™ in the water. Make sure to have at least
3-4 people evenly spaced around the trampoline to help carry the SuperTramp™. NEVER
DRAG YOUR SUPERTRAMP™! YOU MUST LIFT AND SET TO AVOID ANY ACCIDENTAL
TEARING ON SHARP OBJECTS.
buckle
cinch
Make a
'cinch loop'
5
1
8
4
Place anchor bridle
'cinch loop'over frame at
every other corner
Bridle loop
19
Publicité
