Troubleshooting Guide - WaterLink SpinTouch 3580 Manuel D'utilisation

TROUBLESHOOTING

TROUBLESHOOTING GUIDE

Problem
Disc not spinning
Unexpected Results
High pH results
Trouble connecting to
Bluetooth device
Trouble connecting to
computer by USB
"Source" appears on
test screen instead of
"Sanitizer"
Salt results not as
expected
Results not printing
Reason
Lid open, meter not
powered on, low battery,
disk or disk cover pressed
down too tightly on hub
Fast electrical transients
may disrupt operation of
the Spin Touch meter
Did not use disk cover
Water sample temperature
above 100 °F (38 °C)
interferes with pH reagent
Bluetooth not enabled
Too many Bluetooth devices
near the meter
Printer power is ON and Fast
Printer Connection is ON
Broken connection
Wrong Market Type was
chosen
Water sample not between
68-74 °F (20-23 °C).
Sample disk temperatures
above or below this will also
cause artifi cially high or low
readings respectively.
Printer not on
The Spin Touch will
only print to the Mobile
Bluetooth Printer (Code
5-0066)
15
Solution
Close lid, power on meter,
charge the battery or plug meter
into a stable power source,
remove the disk/disk cover and
place back in the meter more
gently
Restart the test to resume
normal operation
Place the disk cover on the disk
and close the lid
For water samples over 100 °F
(38 °C) subtract 0.3 from pH
result or, for the most accurate
result, wait until water sample is
below 90 °F (32 °C) to test
Enable Bluetooth
Have only one device near the
meter
Turn printer power OFF. Or turn
Past Printer Connection OFF.
Press and hold power button for
1 second.
Go to Settings. Change Market
Type to Pool/Spa
Run salt test with sample water
and disk between 68-74 °F
(20-23 °C) or use Salt Screening
Test Chart on disk packaging
insert to fi nd actual salt values.
Turn printer on
Connect to Mobile Bluetooth
Printer (Code 5-0066)