Scope Of Delivery; Basic Device; Switch Box; Accessories Pack - Dimplex LIK 12TU Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
3

Scope of Delivery

3.1 Basic Device

The compact heat pump is supplied complete with all of the im-
portant components of the heating circulation system:
Expansion vessel
Heat circulating pump
Overflow valve and safety components (pressure relief
valve, pressure gauge)
The refrigeration circuit is "hermetically sealed" and contains the
fluorinated refrigerant R410A included in the Kyoto protocol. In-
formation on the GWP value and CO
ant can be found in the chapter Device information. The refriger-
ant is CFC-free, non-ozone depleting and non-combustible.
1
12
3
11
5
6
8
1)
Evaporator
2)
Ventilator
3)
24 l expansion vessel
4)

Switch box

5)
Liquifier
6)
Compressor
7)
Overflow valve
8)
Heat circulating pump
9)
Buffer tank
10) Filter dryer
11) Inspection window
12) Expansion valve
EN-4
equivalent of the refriger-
2
2
4
10
9
7
452160.66.66 · FD 9908
3.2 Switch Box
The switch box is located in the heat pump. After removing the
bottom front cover, the switch box is accessible. Where neces-
sary (repairs on the refrigeration circuit), the switch box can be
unscrewed from the basic device (remove 4x M4 screws) and put
down at the side in front of the device (see Cap. 7.5.2 on pag. 10)
The switch box contains the supply connection terminals, as well
the power contactors, the soft starter unit and the heat pump
manager.
The heat pump manager is a convenient electronic regulation
and control device. It controls and monitors the entire heating
system on the basis of the external temperature, including hot
water preparation and safety systems.
The customer must install the external temperature sensor,
which is included in the scope of supply of the heat pump to-
gether with the necessary fixing accessories.
The enclosed operating instructions describe the function and
use of the heat pump manager.

3.3 Accessories pack

On top of the heat pump:
1 x insulating mat, duct connection
1 x small sealing ring, air intake
1 x large sealing ring, air outlet
Under fan:
8 x vent plugs ø 30 - black
1 x external sensor
1 x Installation and operating instructions haed pump manager
1x dirt trap DN25
1x insertion piece 1 1/4" thread
1x cap nut 1 1/4" thread
1x flat gasket 1 1/4"
Outside the packaging:
1 x installation and operating manual
LIK 12TU
www.gdts.one

Publicité

Chapitres

Table des Matières
loading

Table des Matières