CAPITAL SPORTS INFINITY PRO 2.0 Mode D'emploi page 87

Centering the belt
The belt slides to the left:
When the belt slides to the left, please
fine-tune the rear left screw in a clockwise
direction to the right under high speed
operation (10 km/h). Repeat above steps
until the belt moves back to the center if
the belt still shifts off after 30~60 seconds
under high speed operation.
Lube belt
• After 100 running hours or a total distance of 1000 km[LUBE] is shown on
the display to remind you of the belt maintenance.
• Press STOP or remove the safety switch and switch to standby mode.
When the belt maintenance is complete, press START/Speed+/ Speed-
simultaneously to erase the stored hours/kilometres. Apply the silicone
oil (the whole bottle) to the inside of the tape to care for it. After the oil
has been completely applied to the belt, leave the unit at 10 km/h for 10
minutes to distribute the oil evenly over the belt.
The belt slides to the ight:
When the belt slides to the right, please
fine-tune the rear right screw in a
clockwise direction to the right under
high speed operation (10 km/h). Repeat
above steps until the belt moves back
to the center if the belt still shifts off
after 30~60 seconds under high speed
operation.
EN
87