Olivetti d-Copia 1600 Mode D'emploi page 131

Display
Replace waste
toner box.
Remove paper on
top tray; Start.
Reseat originals
on DP.
Return all
originals to DP.
Set paper
cassette.
Set toner
container.
The Add Toner indicator blinks on
and off.
The Periodic Maintenance
indicator blinks on and off.
The Periodic Maintenance
indicator lights up.
"= = =" appears on the copy
quantity display.
"-" appears on the copy quantity
display.
OPERATION GUIDE
Corrective Procedure
The waste toner box is full. Replace it with a new waste
toner box.
250 copies have been stored on output tray. Remove
the paper, press [Start] and resume copying.
Originals were set in the optional Document Processor
when copying on 2-sides (front and back sides), when
copying from the platen in 2-Sided copy, 2 in 1, 4 in 1 or
when collating copies. Remove the originals from the
Document Processor, replace the originals on the
Original Table after exiting the front and back copying, 2-
Sided copy, 2 in 1, 4 in 1 or Collate Mode and resume
copying.
If the optional Document Processor is being used, there
are originals left on the original table. Remove the
originals, return them to the original table and try
copying them again.
Check the paper cassette that corresponds to the
lighting indicator. Set the cassette.
The Toner Container has not been set. Set the Toner
Container.
There is very little toner remaining. Copying can be
continued for a short while before running out of toner.
Replace the toner container with a new one as soon as
possible.
This is a notification that the time for periodic
maintenance is approaching.
It is time for Periodic Maintenance. Contact your service
representative.
Job Accounting being set. Use the numeric keys to enter
the assigned Section Code to perform copying
operations. Press [Job Accounting] after copying is
finished to display "= = =" again.
The copier is in the Sleep Mode setting. Press [Energy
saver] to exit the mode.
Troubleshooting
Reference
Page
8-5
–
–
–
2-2
8-5
8-5
–
–
6-6
3-9
9-7