Clamp; Clutch Housing - Graco LineLazer GM 3500 Manuel D'instructions

NOTE: A standard steering wheel puller is re-
quired to remove the clamp. Two 1/4–28 x 3 or 4
in. long screws are also needed.
NOTE: Refer to Fig. 38.
1. Loosen the two screws (60) on the clamp (68),
working through the slot at the bottom of the

clutch housing (61).

2. Install two screws (B) of the tool (A) in two of
the threaded holes in the clamp. Tighten the
screws (C) until the clamp comes off.
3. Skip ahead to Reassembly, page 37, Step 3,
or continue below.
NOTE: Refer to Fig. 39.
1. Remove the four capscrews (156) and lock-
washers (157) which hold the clutch housing
(61) to the engine (64).
2. Remove the engine key (66).
3. Pull off the clutch housing (61).
4. Skip ahead to Reassembly, page 37,
Step 1.

Clamp

61
B
C
A
Torque to 125 in–lb (14 N.m)
Fig. 38
Clutch Housing
61
157
156
Fig. 39
60
68
64
66
0047
0048