Mount Guns On The Engine Side Of The Cart; Setup For Spraying Arcs; Adjust Simultaneous Gun Triggering - Graco LineLazer GM 3500 Manuel D'instructions

Positioning the Gun Arm Assembly

Mount Guns on the Engine Side of the Cart

1. See Fig. 15. For both guns, disengage the trigger
cable and engage the trigger safety latch. See page
22.
2. Loosen the gun holder knobs (93) and remove the
gun. Lay the guns out of the way.
3. Remove the knobs (E) on both carriage clamps
(B,D); the carriage bar (4) and extension clamps (A)
will drop down.
4. Lift the front tire and rotate the carriage bar 180 un-
der the cart and to the other side of it.
5. Position the carriage bar below the carriage clamps
(B,D). Align the holes in the top of the extension
clamps (A) with the holes in the carriage bar clamps
and install the knobs (E).
6. Loosen the post/arm clamps (6) and rotate the guns
forward. Retighten the clamps.
Fig. 16

Adjust Simultaneous Gun Triggering

WARNING
To reduce the risk of a fluid injection injury, always
disengage the trigger cable to the gun (s) and
engage the guns' trigger safety latch before moving
or adjusting the guns or gun arms.
1. Align the front of the guns by adjusting the gun arms.
See page 17.
A
6
1
4
7. Install the guns. Note which gun and position on the
dual gun selector each of the cables (1 and 402)
goes. Route the hoses and cables to prevent kinking.
Position the spray tip guards. Disengage the gun trig-
ger safety latches. Engage the trigger cables.

Setup for Spraying Arcs

1. See Fig. 16. Disengage the trigger cable (1) and en-
gage the gun trigger safety latch. See page 21.
2. Loosen the arm clamp (6) and rotate the arm (A)
back near the rear tire and then position the arm so
the spray tip guard aligns with the back axle of the
unit. Retighten the clamp.
3. Extend the carriage bar (4) or second gun bar (404)
so you can easily watch the line you are painting and
also to avoid running over the paint line. See page
17.
4. Adjust the vertical and horizontal position of the gun.
5. Spray the arc from the outside.
7360C
2. Position the dual gun selector to trigger both guns.
See page 21.
3. Start the sprayer, using water, or spray on card-
board. See page 13. Trigger the guns to see if the
lines begin at the same time and place.
If one gun triggers before the other gun, reduce the
cable tension of the gun that triggers first. See Ad-
just the trigger cable tension on page 22 .
If one line starts in front of the other, adjust the posi-
tion of the guns. See page 17.
Trigger the guns to recheck the adjustments.