Field & Wiring Harness - Graco LineLazer GM 3500 Manuel D'instructions

NOTE: Refer to Fig. 37.
1. Loosen the four setscrews (62) holding the field (70)
to the clutch housing (61). Unplug the wiring harness
(58) from under the engine mounting plate. Pull the
field out to expose the black and white wires (58).
70
57
Fig. 37
Field & Wiring Harness
62
61
2. Pull the caps (A) off the wire screws (57) in both
places on the field. Loosen the screws and release
the wires (58).
3. Skip ahead to Reassembly, page 37, Step 4.
58
A
0046