Graco LineLazer GM 3500 Manuel D'instructions page 87

1. Working under the mounting plate (25) of the cart, re-
move the screw (51), lockwasher (132) and washer
(50) which hold the clutch housing (61) to the cart.
See Fig. 35.
2. Still working under the mounting plate, remove the
two locknuts (40), and then pull the screws (63) out
of the base of the engine. Disconnect the red wire
from the engine lead. Disconnect the black and white
wires (58) from the field. Pull the wires carefully
through the grommets before removing the engine.
See Fig. 35 and 36.
67
59
61
104
25
50
132
51
Fig. 35
Engine
3. Lift the engine carefully and place it on a work bench.
4. Remove the Field and Wiring Harness, Clamp and
Clutch Housing, as instructed on pages 35 and 36.
5. Skip ahead to Reassembly, page 37, Step 1.
NOTE: All service to the engine must be performed by
an authorized HONDA dealer.
TO FIELD
63
TO ENGINE
Fig. 36
40
0045
View from under engine mounting plate
RED
58
0032