Additional Clearances - Rinnai RUCS65i Manuel D'installation Et D'utilisation

Additional clearances

Check to determine whether local codes supersede
these clearances.

Avoid termination locations near a dryer vent.

Avoid termination locations near commercial
cooking exhaust.

Avoid termination locations near any air inlets.

You must install a vent termination at least 12
inches above the ground or anticipated snow
level.
RUCS65i, RUCS75i
The vent for this appliance shall not terminate

Over public walkways; or

Near soffit vents or crawl space vents or other
area where condensate or vapor could create a
nuisance or hazard or cause property damage; or

Where condensate or vapor could cause damage
or could be detrimental to the operation of
regulators, relief valves, or other equipment.
Important considerations for locating vent
termination under a soffit (ventilated or unventilated
or eave vent; or to a deck or porch)

Do not install vent termination under a soffit vent
such that exhaust can enter the soffit vent

Install vent termination such that exhaust and rising moisture
will not collect under eaves. Discoloration to the exterior of
the building could occur if installed too close.

Do not install the vent termination too close under the soffit
where it could present recirculation of exhaust gases back
into the combustion air intake part of the termination.
(0.30 m ) to
an inside
corner
12"
V
12"
INSIDE
CORNER
36"
V
(0.30 m) between
terminals at same
level
KCM Series Manual
(50 mm) between
terminals at same level
12"
(0.30 m) to an
inside corner
(1.52 m)
between
terminals at
different levels
V
(1.52 m)
vertically
between
60"
terminals
V
RUS65e, RUS75e
(0.91 m) to
ventilated or
unventilated soffit
or eve vent; or to a
36"
deck or porch
2"
(1.52 m) vertically
between terminals
60"
60"
V
(0.61 m) to wall or parapet
24"
V
12"
(0.30 m) between
V V
terminals at same
level
V
9