Electrical Characteristics; Pellet Loading - EdilKamin INPELLET 49 Installation, Usage Et Maintenance

Nominal power
Effi ciency nominal power
Emissions CO (13% O2) nominal power
Smoke mass nominal power
Reduced power
Effi ciency reduced power
Emissions CO (13% O2) reduced power
Smoke mass reduced power
Maximum overheated smoke
Minimum draught
Autonomy (min/max)
Fuel consumption (min/max)
Hopper capacity
Heatable volume *
Weight including packaging
Smoke outlet pipe diameter (male)
Air intake pipe diameter (male)
* The heatable room dimensions are calculated home insulation in compliance with Italian law 10/91, and subsequent changes
together with an expected heat output of 33 Kcal/m³ per hour.
* It is also important to consider the position of the insert in the room to be heated.
N.B.
1) bear in mind that external devices may cause interference.
2) caution: live parts. Servicing and/or inspections must be carried out by qualifi ed staff.
Power supply
Average power consumed
Power consumed upon ignition
Remote control frequency
Protection on electronic board *
The data shown above is purely indicative. EDILKAMIN s.p.a. reserves the right to make changes to these products
to improve their performance with no prior warning.

PELLET LOADING

The hopper is fi lled via the loader door (P), fi xed on the mantel.
The door is held closed by a magnet; to open/close use the holes on it.
Pour the pellets directly from the bag (about half a bag) or through a bailer
(scoop provided).
Check to make sure that all the pellets poured in have reached the hopper
without becoming blocked in the fl exible tube and then pour in the remaining
half of the bag.
FEATURES
THERMO TECHNICAL CHARACTERISTICS

ELECTRICAL CHARACTERISTICS

120
400
- 25
-
6,5
91,8
45,9
4,75
1,9
90,8
386,7
2,46
130
12
4,5 / 14
0,5 / 1,5
10
170
157
80
50
230Vac +/- 10% 50 Hz
W
W
Radio waves 2,4 GHz
Fuse 2AT, 250 Vac 5x20
P
kW
%
ppm
g/s
kW
%
ppm
g/s
°C
Pa
hours
kg/h
kg
m³
kg
mm
mm