First Use - Helite E-TURTLE Manuel D'utilisation

2. First use

AUTONOMOUS AIRBAG SYSTEM (WITHOUT FORK SENSOR):
1. Recharge your vest (see page 24).
2. Switch on the vest by quickly pressing the ON/OFF button three times. The LED
flashes green and you hear a beep.
3. You are ready to ride.
See page 26 for precautions before use.
OPTIONAL VERSION WITH FORK SENSOR (SDU)
A. PAIR THE FORK SENSOR AND THE VEST
Before using your vest for the first time, you need to pair (i.e. associate) the vest with
the fork sensor. To do so, you need your vest, the fork sensor and the magnet.
CAUTION If other vests are paired to the sensor, they must be switched off.
Check that the e-cartridge is properly screwed and connected to the vest.
1. Switch on the vest by quickly pressing
the ON/OFF button three times. The LED
flashes green and you hear a beep.
2. Press the ON/OF button for 3 seconds
until the LED turns blue. Release the button
and go to the next step.
3. Place the magnet on the fork sensor
over the round slot. Please note that you
only have 30 seconds to effect this
procedure.
y If you hear a long beep: the vest and the
fork sensor are paired.
y If you hear a short beep: the fork sensor
has recognized the vest. The 2 sensors
have already been paired.
y If you hear several beeps (+ red LED):
the pairing has failed. Either you have
taken more than 30 seconds to place the
magnet over the sensor, or you already
have 5 fork sensors associated with the
vest. In the first case, repeat the pairing
procedure. In the second case, you must
delete all the sensors associated with the
vest (see page 25).
User Guide
:
21
x3
3
sec