Olivetti d-Copia 120D Mode D'emploi page 67

A: Misfeed in the paper feed area
1
Gently remove the misfed paper from the paper feed area as
shown in the illustration. When
misfed paper is not seen from the paper feed area, pull out the
paper tray and remove the misfed paper. If the paper cannot be
removed, proceed to "B: Misfeed in the fusing area".
The fusing unit is hot. Do not touch the fusing unit when
removing misfed paper. Doing so may cause a burn or other
injury.
• Do not touch the surface of the drum (green portion) of the
• Toner on the paper may stain the paper transport area,
2
Close the side cover by pressing the round projections near
the side cover open button. The misfeed (
out and the start (
B: Misfeed in the fusing area
1
Lower the fusing unit release
lever.
drum cartridge when removing the misfed paper. Doing so
may damage the drum and cause smudges on copies.
resulting in smudges on copies.
) indicator will light up.
blinks in the display and the
) indicator will go
Fusing unit release lever
8
65