Olivetti d-Copia 120D Mode D'emploi page 42

4
Press the start (
Scanning will start and the scanned data will be transfered to the
application.
• If the following screen appears, select
• If step 4 is performed with the "Show
Opening the scanner driver and scanning from your computer
Follow the steps below to open the scanner driver setup screen. As an example, this
instruction is given using Desktop Document Manager as an image capture
application.
• Scanning is not possible during a copy and print job.
• The method for starting the scanner driver differs depending on the type
• When using the scanner driver to scan an original that has been placed
40
Button Manager and click "OK". Button
Manager starts and the application
associated with Button Manager starts. If
you want only Button Manager to start in
this case, set up Button Manager for use in
Windows as explained in "Setting up the
Button Manager" (p.34).
TWAIN setting screen when scanning" checkbox selected in the
Scan Parameter Setting Dialog Box (p.36), the TWAIN settings
screen (p.41) will automatically appear. Check the settings, and
then press the start (
the TWAIN setting screen to start scanning. The scanned data
will be transferred to the application.
of application. Refer to the manual or the help file of your application.
in the SPF. If you perform a pre-scan (see the online manual or the help
file for the scanner driver), the original in the SPF will be output to the
exit area after scanning. To scan the original after the pre-scan, place
the original in the SPF once again.
) key.
) key again or click the "Scan" button in
Olivetti d-Copia 150D
Olivetti Personal MFP Series
Olivetti Personal MFP Series