Status Indicators - Olivetti d-Copia 120D Mode D'emploi

STATUS INDICATORS

When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the relevant page.
Be sure to use only genuine OLIVETTI parts and supplies.
Indication
Drum replacement
required indicator
TD cartridge
replacement
required indicator
Misfeed indicator
SPF misfeed
indicator
Power save indicator is
steadily lit.
The paper tray indicator is
blinking.
"CH" is blinking in the
display.
"CH" is steadily lit in the
display.
"P" is blinking in the display.
A letter and a number appear
alternately.
A letter and a number appear
alternately.
Steadily Replacement of drum cartridge will be needed
lit soon. Prepare a new cartridge.
Drum cartridge must be replaced. Replace it with
Blinking
a new one.
Steadily Replacement of TD cartridge will be needed
lit soon. Prepare a new cartridge.
TD cartridge must be replaced. Replace it with a
Blinking
new one.
A misfeed has occurred. Remove the misfed
Blinking paper referring to the description of "MISFEED
REMOVAL".
An original misfeed has occurred in the SPF.
Blinking Remove the misfed originals referring to the
description of "D: Misfeed in the SPF".
The unit is in the preheat mode. Press any key to
cancel the preheat mode.
The unit is in the auto power shut-off mode.
Press the start (
shut-off mode.
The paper tray is not installed properly. Push the
tray into the unit securely.
The TD cartridge is not installed. Check if the
cartridge is installed.
Side cover is open. Close the side cover
securely by pressing the round projections near
the side cover open button.
The paper tray is empty, or single bypass has
been selected in the printer function.
Load paper.
A misfeed has occurred in the paper tray or
single bypass. Remove the misfed paper.
The scan head locking switch is locked. Unlock
the scan head locking switch and turn the power
switch off/on.
The unit will not function. Turn the power switch
off and then switch it on, and if there is again an
error, remove the power cord from the outlet, and
contact your authorized service representative.
Cause and remedy
) key to cancel the auto power
Page
71
59
71
58
64
67
55
55
–
58
–
15, 17
64
8
9
–
63