Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Never fill the mixing bowl 7 with more than a
total of 1.5 kg of ingredients. Otherwise the
motor may be damaged.
5. Replace the mixing bowl 7 onto the mixing
stand 6.
6. Press the unlocking button 5 and lower the hol-
der downwards.
7. Place the hand element 0 on the holder so that
it firmly engages.
8. Slide the lid 9 into the guiderails on the mixing
stand 6 so that it is firmly seated.
Note:
Should you wish to add ingredients whilst mixing,
open the filler opening 8 and insert them through
it. To avoid a splattering of the ingredients, be sure
to reclose the filler opening 8!
You can also use the hand mixer without the mixing
stand 6. Especially with minor amounts of liquids
you are advised to use the hand mixer without the
mixing stand 6. Otherwise, the liquid may not be
completely captured and thus not mixed thoroughly.
Attention:
Under no circumstance should you use receptacles
made of glass or other very fragile/easily breakable
materials. These containers can be damaged and
then cause potentially serious injuries.
9.
Insert the plug into a mains power socket.
10. To set the mixer into motion, push the speed
switch 1 to the desired speed setting. You
can select between 5 speed settings or the
turbo button 2 (see section "Speed levels").
Warning:
Do not operate the mixer for longer than 10 minutes
in one session. After 10 minutes, allow the appliance
to rest until it has cooled itself down. Otherwise, the
appliance could be irreparably damaged.
Note:
If ingredients become stuck to the side of the mixing
bowl 7 and they cannot be captured with the
kneading hooks r/ whisks e, switch the hand mixer
off. Remove the lid 9. Use the dough scraper t to
push them back into the middle of the mixing bowl 7.
Replace the lid 9. Switch the hand mixer back on.
11. To remove the contents of the bowl, switch off
the blender. Pull the lid 9 off to the side.
12. Press the unlocking button for the handmixer 4,
remove the handmixer and set this to one side.
Press the ejection button q if required to
release the whisk e or the kneading hooks r.
Note:
For safety reasons, the whisk e and kneading
hooks r can only be released if the speed switch 1
is set to the position "0" or „ " .
13. Press the unlocking button 5, flip up the bracket
and remove the mixing bowl 7 from the mixing
stand 6.
- 6 -
Publicité
Chapitres
Table des Matières
