Electrical Connection - Hamron 008052 Mode D'emploi

EN
• The installation of the winch and/or front
guard can affect the release of the air
bags on the vehicle. If the vehicle has air
bags, check for this reason whether the
system is approved for installation of a
winch.
1. If you are making your own winch
attachment, follow the instructions below.
The mounting plate must be made of
steel and at least 6 mm thick. Fasteners
must be made of high-tensile steel with a
yield limit of at least 640 MPa (screws of
strength class 8.8 or higher). Inadequate
attachment will invalidate the warranty.
2. The screws for the 4 attachment points
for the winch must be M10 x 32 with a
strength rating of 10.9, tightened to at
least 60 Nm, and provided with suitable
screw lock to prevent them coming loose
unintentionally.
3. The line rollers must be installed so that
they guide the line/wire correctly on the
drum.
4. Installed with the opening in the direction
of pull. The traction is not put on the line
rollers, it only controls the wire.
5. The dimensions of the winch and winch
attachments are provided in the technical
data.
INSTALLATION OF RELAY BOX
Horizontal installation of drawbars over
the drum
1. Fit the long brackets (hook forward) with
spacers on the relay box and tighten.
FIG. 1
2. Fit the relay box on the drawbars, with the
bracket hooks forward, and tighten the
screws on the back.
FIG. 2A-E
3. The installation is now complete. Electrical
30
connection of the winch as per the wiring
diagram
Vertical installation of drawbars over
the drum
1. Fit the angle brackets on the long
brackets.
FIG. 3
2. Fit the assembled brackets (hook forward)
on the relay box and tighten.
FIG. 4
3. Fit the relay box on the drawbars, with
the bracket hooks forward, and tighten
the screws on the back. The installation is
now complete. Electrical connection of the
winch as per the wiring diagram.
FIG. 5
Mounting on motor
1. Undo the screws on the side of the relay
box, fit the small bracket on the side of
the box, and tighten.
FIG. 6
2. Undo the drawbar screws on the motor
and fit the relay box in place.
FIG. 7
3. Tighten the drawbar screws.
The installation is now complete.
Electrical connection of the winch
as per the wiring diagram.
FIG. 8

ELECTRICAL CONNECTION

The winching is powered by the electrical
system in the vehicle. It is important, however,
that the battery is fully charged and that the
electrical connections are in good order. Keep
the engine running while winching to keep
the battery fully charged. Make sure that the
wires are connected correctly as shown in the
diagram.