Cleaning - SilverCrest SSTB 10 B2 Mode D'emploi Et Consignes De Sécurité

Fault
The remote control
does not work.
NOTE
► If you are unable to resolve the problem by applying any of the aforemen-
tioned methods, please contact the Customer Service department.

Cleaning

Risk of fatal injury from electrocution!
► Remove the mains adapter from the power socket before starting to clean
the device.
Damage to the device!
► To avoid irreparable damage to the device, ensure that no moisture gets
into it during cleaning.
► Do not use caustic, abrasive or solvent-based cleaning materials.
These can damage the surfaces of the device.
♦
SSTB 10 B2
Possible cause
The remote control is
pointing the wrong way.
The distance between
the remote control and
the device is too great.
The batteries in the
remote control are empty.
DANGER
CAUTION
Clean the surfaces of the device with a soft, dry cloth. For stubborn dirt, use
a slightly damp cloth with a mild detergent.
Remedy
Point the remote control towards the
infrared sensor on the front of the
device.
Move the remote control closer to
the device.
Replace the batteries.
GB │ IE │
35 ■