Installer Setting - Occupancy Duration Time Setting - LG PREMTB10U Manuel D'installation Et D'utilisation

Installer setting – Occupancy Duration Time Setting
It is a function that sets the light-on/occupancy duration after motion is detected when installing
an occupancy sensor.
INSTALLATION INSTRUCTIONS
If pressing button long for 3
1
seconds, it enters into
Occupy sensor 'occupy maintain' time
setting installer setup mode.
- If pressing once shortly, it enters into
user setup mode. Please press more
than 3 seconds for sure.
If moving to room temperature perception
2
sensor selection menu by pressing
button, it indicates as picture below.
Set Thermistor value by pressing
3
button.
Function Code Setting value
value Guard time
00 0 minute
01 10 minutes
02 30 minutes
03 60 minutes
Press button to save.
4
Pressing button will exit settings mode.
5
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
93