Installer Setting - Guard Timer - LG PREMTB10U Manuel D'installation Et D'utilisation

Installer setting – Guard timer
It is a function that sets the minimum running time of outdoor unit cycle mode when switching
from cooling mode to heating mode and vice versa during Auto Operation mode.
Under the condition of cooling/heating switching, it switches between cooling and heating mode
after operation during the time scheduled in the Guard timer.
INSTALLATION INSTRUCTIONS
If pressing button long for 3
1
seconds, it enters into Guard timer
installer setup mode.
- If pressing once shortly, it enters into
user setup mode. Please press more
than 3 seconds for sure.
If moving to room temperature perception
2
sensor selection menu by pressing
button, it indicates as picture below.
Set Thermistor value by pressing
3
button.
Function Code
Setting value
value Guard time
0 0 minute
1 15 minutes
2 30 minutes
3 45 minutes
4 60 minutes
Press button to save.
4
Pressing button will exit settings mode.
5
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
85