Installer Setting - Test Run Mode - LG PREMTB10U Manuel D'installation Et D'utilisation

Installer Setting - Test Run Mode

After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.
INSTALLATION INSTRUCTIONS
If pressing button long for 3
1
seconds, it enters into Thermostat
installer setup mode.
- If pressing once shortly, it enters into
user setup mode. Please press more
than 3 seconds for sure.
- Please cancel the right and left of wind
direction for RAC product.
Function Code
Setup figure '01' blinks at the lower part
2
of indication window.
You can select test heating operation
mode for some products.
Some models have Heating test run
mode.
In that case, Select test run mode by
pressing button.
01: cooling
02: heating
Press button to start.
3
4 During the test run, pressing the below
button will exit the test run.
- Select operation mode, temperature
up/down, fan speed, wind direction,
start/stop button.
67
Set