Carrying Handle - Sony BC-L50 Mode D'emploi

Location and Function of Parts
3 Battery pack attachment sections
and charge indicators 1/2
Attach BP-L40/L60/L60A/L90/L90A
lithium-ion battery packs.
When you detach a battery pack, pull
it up, holding the release button in.
The charge indicators indicate the
progress or result of charging by
flashing or lighting in red, orange and
green.
Flash in orange: Charge in progress
(charged 0% to 80%)
Light in orange: Charge wait
(charged 80% and the other
battery pack is now being
charged).
This status arises only when you
attach two battery packs.
Flash in green: Charge in progress
(charged 80% and over)
Light in green: End of charging
Flash in red and green: One of the
following conditions exists.
• Before charging, the output
voltage of the charger was some
value other than the specified
voltage.
• Once charging started, the
battery voltage did not rise to
the charge voltage within a
specified period.
• Once charging started, the
battery connector voltage rose
above the specified voltage.
• Once charging started, the
battery connector voltage
dropped below its initial value.
• A charge current other than that
corresponding to the attached
battery pack was detected
during charging.
26
If any of the above conditions
occur, try recharging the battery
pack two or three times. If the
condition persists, the battery
pack is likely defective and
should be replaced.
If you attach a battery pack not
supported by this unit, the indicators
will also flash in red and green.

4 Carrying handle

Pull out to carry this unit.
5 AC IN (AC power input)
connector
Used to connect the charger to an AC
outlet with the supplied AC power
cord.
6 Plug holder receptacle
The supplied plug holder secures the
AC power cord so that it will not
come loose from the charger.
Plug holder
(supplied)
When removing