Turning The Power On; Changing Between Input Terminals; Turning The Power Off - Sharp LL-T15G4 Mode D'emploi

Connecting the monitor and turning the monitor on and off

Turning the power on

1. Press the monitor's power button.
2. Turn on the computer.
The power LED will be lit green, and the screen
will display an image.
Power LED
- If the input terminal to which the computer is
connected has not been selected, the screen
will not be displayed. If necessary, perform input
terminal switching.
Notes:
- When using an analog signal, perform an
automatic screen adjustment under the following
conditions (p.16):
- Using the monitor for the first time.
- After having changed the system settings
during use.
- Depending on the type of computer or OS, you
may need to install the monitor set-up
information on your system. (p.26)
- When connecting to a notebook, if the notebook
computer's screen is set to display at the same
time, the MS-DOS screen may not display
properly. In this case, change the setting to
display only the LCD monitor.

Changing between input terminals

Use the INPUT button to switch between signal
input terminals.
Analog RGB input
terminal
INPUT
INPUT
<ANALOG>
Note:
- When there is no input signal, [NO SIGNAL] is
displayed.

Turning the power off

1. Turn the computer off.
2.Press the monitor's power button.
The power LED will disappear.
Power button
If the monitor is not going to be used for a long
period of time, be sure to unplug it from the AC
outlet.
DVI-D input
terminal
INPUT
<DIGITAL>
13
Power LED Power button