Adjusting The Screen Display (When Using A Digital Signal) - Sharp LL-T15G4 Mode D'emploi

Adjusting the screen display
Adjustments can be made using OSD (On Screen
Display) Menu provided.
1. Display an image that makes the entire screen
very bright. If using Windows, you can open and
use the Adjustment Pattern on the accompanying
Utility Disk. (p.16)
2. Press the MENU button 3 times.
The WHITE BALANCE Menu will be displayed.
WHITE BALANCE
COOL STD WARM USER
R-CONTRAST
G-CONTRAST
B-CONTRAST
1024x768 DIGITAL
V : 6 0Hz H : 4 8.4kHz
At this point relevant menu options can be
adjusted.
Each time the MENU button is pressed the next
menu is selected. (WHITE BALANCE → MODE
SELECT → OSD Menu disappears)
Notes:
- Like when making an analog connection, the
ADJUSTMENT Menu and the GAIN CONTROL
Menu are displayed. However, you don't need to
adjust these items.
- The OSD Menu automatically disappears
approximately 30 seconds after the last
command.
(When using a digital signal)
WHITE BALANCE Menu
WHITE BALANCE
COOL STD WARM USER
R-CONTRAST
G-CONTRAST
B-CONTRAST
1024x768 DIGITAL
V : 6 0Hz H : 4 8.4kHz
Notes:
- On settings other than [STD] not all gradations
can be displayed. To display all gradations, set
to [STD].
- If [DISPLAY MODE] is set to [sRGB] or [VIVID],
no other setting than [STD] can be selected.
- Use the buttons to select [COOL], [·], [STD],
[·], [WARM] or [USER].
- Selecting [USER] will display the setting values
for [R-CONTRAST], [G-CONTRAST] and
[B-CONTRAST], in order to make fine
adjustments.
- Use the / MODE button to select
[R-CONTRAST], [G-CONTRAST] and
[B-CONTRAST].
- To go to the next menu: MENU button
COOL ....... Color tone bluer than standard
• ............. Color tone slightly bluer than standard
STD .......... Color tone standard setting
• ............. Color tone slightly redder than standard
WARM ..... Color tone redder than standard
USER
R-CONTRAST .....
G-CONTRAST .....
B-CONTRAST .....
20
button for blue-green
button for red
button for purple
button for green
button for yellow
button for blue