Instructions For Attaching A Vesa-Compliant Arm - Sharp LL-T15G4 Mode D'emploi

Instructions for attaching a VESA-compliant arm

An arm or stand based on the VESA standard
(commercially available) can be attached to the
monitor.
Procurement of the arm or stand is at the
customer's discretion.
When choosing the arm to be installed please take
note of the following points.
- The arm should be compatible with the VESA
standard, and there must be a gap of 75 mm x
75 mm between the screw holes on the section
to be attached.
- The arm must not fall off or break off after being
attached to the monitor.
- Do not over bend the cable or add extension
cords as this could lead to malfunction.
1. Turn off the monitor's and computer's power and
remove the AC plug from the AC outlet.
2. Remove the cables.
3. Spread out a soft cloth on a suitable horizontal
surface.
4. Being careful not to damage the monitor, gently
lay the monitor on it display-side down.
5. Remove the four screws and then remove the
stand from the monitor.
Notes:
- The stand is specially made for use with this
monitor. Once having removed the stand,
never attempt to attach it to another device.
- Once having removed the screws, store them
together with the stand and if the stand is ever
re-attached be sure to use the original screws.
Using different screws could lead to a
malfunction.
6. Attach the arm to the monitor with four screws.
Note:
- The screws used to attach the arm should be M4
screws with a length of 8 - 10 mm protruding
from the surface to be attached. Using different
screws could cause the monitor to fall off or to be
internally damaged.
Screw used to attach arm
Arm
Part of monitor to which arm is
attached
7. Connect the cables and the power cord.
30