Intended Use; Start-Up Of The Device/Introduction - AEG SR 4345 CD Mode D'emploi

Radio stéréo avec lecteur cd
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
English
26
5 FUNCTION Function selector switch (FM / AUX/OFF /
CD)
6 TUNING control
7 PUSH/OPEN (push/open) CD tray
8 Loudspeaker
9 REP button (Repeat)
10
button (forward search)
11
button (Stop)
12
button (Play/Pause)
13
button (reverse search)
14 PROG button (memory)
15 LCD-display
16 AC Mains connection
Bottom side (without illustration)
Battery compartment
Dipole antenna

Intended Use

This device is used for
• The reception of radio programmes
• Playing back audio CDs
• Sound playback from external audio sources.
It is intended exclusively for this purpose and may only be
used as such.
It may only be used in the manner described in these instruc-
tions for use. The device must not be used for commercial
purposes.
Any other use of this device is considered to be contrary to
the intended use and may result in damage to materials or
even personal injury.
The firm ETV – Elektro-Technische Vertriebsgesellschaft mbH
does not accept any liability for damage caused as a result of
the use of this device contrary to its intended use.

Start-up of the device/introduction

• Please read the operating instructions carefully before
using the device for the first time!
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power Supply
• Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed 230 V / 50 Hz
safety power socket and the mains connector AC ~ (16)
on the back of the machine.
• Ensure that the voltage is the same as that indicated on
the model identification plate.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment on the bottom.
• Insert 6 batteries of type UM2/R14 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
• If the device is not used for a long period of time, remove
the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
While doing so, guide the dipole antenna through the
small notch on the battery compartment.
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fire. There is a
danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD tray (3) by pushing the PUSH/OPEN button
(7).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.
Volume
The desired volume can be sent using the VOLUME
regulator (4).
Switch-off
The machine is switched off when the function selector switch
(5) is turned to the AUX/OFF position. Unplug the device.
AUX IN socket
To connect analogue replay devices. Via this socket you can
also hear the sound of other playback devices such as MP3
players, CD players etc. through the loudspeakers.
1. Please connect the external device with a 3.5 mm stereo
jack plug to the AUX socket (2).
2. Set the function selector (5) to AUX/OFF. The device
switches automatically to AUX IN operation.
3. Through the loudspeakers you can hear the playback of
the sound from the external device; with the VOLUME
control (4) you can change the volume. The CD buttons
do not have any function.

Publicité

Table des Matières
loading

Table des Matières