Technical Information - Zanussi ZDF16021WA Notice D'utilisation

Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not suf-
ficient. Adjust the rinse aid selector to a
higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase or
with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use
rinse aid together with the combi detergent
tablets.
Refer to 'HINTS AND TIPS' for other pos-
sible causes.
How to activate the rinse aid dispenser
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.
24
2. Press and hold, at the same time,
3. Press
4. Press
5. Press the on/off button to deactivate the
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
setting mode, refer to "Setting and starting
a programme".
and
,
• The indicators of
• The indicator of
flash.
• The display shows the current setting.
Rinse aid dispenser off.
Rinse aid dispenser on.
appliance and to confirm the setting.
2)
until the indicators of
and start to flash.
.
and go off.
continues to
to change the setting.
600 / 850 / 625
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
0.99 W
0.10 W
www.zanussi.com
12