Technical Information - Zanussi ZDT 16011 FA Notice D'utilisation

Problem
Whitish streaks and stains
or bluish layers on glasses
and dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and
matt.
Activating the rinse aid dispenser with the
multitab option activated
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode, refer to 'SETTING AND START-
ING A PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) start to flash.
3. Press function button (B).
• The indicators of function buttons (A)
and (C) go off.
• The indicator of function button (B) con-
tinues to flash.

Technical information

Dimensions
26
Possible cause
The set level of the water softener is
incorrect.
The cap of the salt container is loose.
The released quantity of rinse aid is
too much.
The quantity of detergent was too
much.
The released quantity of rinse aid
was not sufficient .
The quality of the detergent can be
the cause.
The programme had no drying phase.
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
The quality of the combi detergent
tablets can be the cause.
Width / Height / Depth (mm)
Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area.
Tighten the cap.
Decrease the released quantity of
rinse aid
.
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
Increase the released quantity of rinse
aid.
Try a different brand of detergent.
Set a programme with the drying
phase.
Make sure that there is rinse aid in the
rinse aid dispenser.
Try a different brand of rinse aid.
• Try a different brand of combi deter-
gent tablets.
• Activate the rinse aid dispenser and
use the rinse aid together with the
combi detergent tablets.
• The display shows the setting of the rinse
aid dispenser.
4. Press function button (B) to change the
setting.
5. Deactivate the appliance to confirm the set-
ting.
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Possible solution
Off
On
596 / 818 - 898 / 596
www.zanussi.com