Safety Information - Detax freeprint IBT Mode D'emploi

intended use
Resin for dental 3D printing
indication
Othodontic transfer trays for positioning brackets
Patient target grouP
Persons being treated in the context of a dental procedure.
intended users
Orthodontist, dentist, dental technician
suitable for the following dlP-Printer
asiga miicraft
385 nm 385 nm
MAX UV MiiCraft y-Serie
Pro2 UV
Pico2 UV
Printers may only be operated using material parameters authorised by DETAX!
Processing
► The properties of the final product depend, among other things, on post-processing. Correct post-exposure is
important for biocompatibility. Therefore it must be ensured that the light unit is in an orderly condition and that
the moulds are completely cured (observe process description on page 8).
► After storage, the material in the bottle should be shaken intensively and homogenized with a bottle roller before
use.
► Minimum material thickness for the design is 1.5 mm
► Maximum curing depth* at direct post-exposure:
clear: 6 mm
*In case of large objects and exposure on both sides, the material thickness can be up to 12 mm.
► Processing temperature 23 °C ± 2 °C.

safety information

► Only for the specified intended use by trained specialists.
► Avoid direct contact with the liquid material and the components before post-curing,
especially in pregnant / breastfeeding women. Irritating to eyes and skin (sensitization possible).
► Wear personal protective equipment (protective gloves, goggles) when handling the uncured material.
► Wear suitable personal protective equipment (protective gloves, goggles, face mask)
when finishing the cured material.
6
rapidshape w2P
385 nm 385 nm
DII-Serie Solflex Series
► After contact with eyes rinse thoroughly with water immediately and consult a doctor.
► After contact with skin wash immediately with water and soap.
► Biocompatibility is only guaranteed with complete polymerisation.
► Refer to the relevant safety data sheet for hazard and safety information.
notes
► DETAX shall not be held liable for any damage caused by misuse.
► Always keep container tightly sealed, immediately close the container carefully after each use.
► Read and understand the safety data sheet!
for users and/or patients:
Any serious incidents occurring in relation to this product should be reported immediately to incident@detax.de and to
the competent authority of the Member State in which the user and/or patient is established.
storage
freePrint® ibt is to be stored dry (at 15 °C - 28 °C) and protected from light. Minimal influence of light can already
induce polymerisation.
contraindication
Contains (meth)acrylics and phosphine oxide.
Some ingredients of freePrint® ibt may cause allergic reactions in predisposed persons. In such cases refrain from
using the product. freePrint® ibt only insert intraorally in completely polymerised state.
adVerse effects
Product may cause allergic reactions.
disPosal
Disposal of the contents/container must be carried out in accordance with the local/regional/national and international
regulations.
symbols: storage:
28 °C
Medical Device
82 °F
15 °C
59 °F
application:
At 23 °C ± 2 °C
7