Cut-Off Machine Cart - Stihl FW 20 Notice D'emploi

English

Cut-off machine cart

+
+
A basic machine and an attachment kit
are combined to produce a complete
cart FW 20.
The complete instruction manual for the
cart FW 20 therefore consists of two
instruction manuals – one for the basic
machine FW 20 and one for the
attachment kit FW-TS.
Always read both instruction manuals
carefully before using your machine for
the first time and keep them safe for
future reference.
Additionally, observe the instruction
manual of the cut-off machine used.
6
Mounting
Installing the mount
1
1
Insert bolts (1) M8x25 from above
N
through the oblong holes in the
mount (2)
Position the mount so that the
N
notch (3) in the upper oblong hole is
centered in relation to the bolt
Screw on and tighten the hexagon
N
nut with washer
Mounting the cut-off machine
2
2
1
1
Position the cut-off machine so that
N
the pins (1) protrude into the holes
in the support (2)
3
4
The handlebar (3) must lie in the
N
bracket (4)
6
5
7
Swivel the locking lever (5) over the
N
hand guard (6) and engage
The pawl (7) disengages and the
N
handle is now fixed in place
FW 20 - TS 700, TS 800