iwc DA VINCI CHRONOGRAPH Mode D'emploi page 25

Taking the bracelet apart and removing individual links
about 3 millimetres (2) with the second special tool.
Determining bracelet length
links from each half of the bracelet, if possible, to ensure that the clasp can
be worn more or less at the centre of the wrist.
Keep the surplus links and the separating tools in a safe place for use in any
adjustment at another time.
Open the clasp by pressing the button on the side. Lay
the bracelet with its top surface on a firm base. Using
the special tools provided, you can now push down the
securing pin (1) at the desired point of separation and,
at the same time, displace the pivot pin laterally by
Now pull the protruding pivot pin from the bracelet (3).
The metal brace let is now separated, and you can
adjust the length of the bracelet by removing or adding
individual links.
Place the watch with the bracelet open around your
wrist and estimate the number of surplus bracelet
links that you can now remove from the bracelet (as
described above). If you need to shorten the bracelet by
several links, you should remove the same number of
22 | 23