Technical Data - Olympia A 230 Plus Mode D'emploi

Laminator A 230 Plus / A 330 Plus

Technical Data

The lamination result is not as good
as expected - the laminated foil is
not completely transparent or is
wavy, or the laminated material is
damaged.
Technical Data
Laminating system:
Working width
Laminating temperature
Laminating width (max.)
Warm-up phase (seconds)
Foil thickness
Laminating speed:
Automatic switch-off
in case of overheating
Indicator lights
Cool down phase
Rollers
Power supply
Power consumption
Dimensions
Weight
Suitable materials
(hot lamination)
Suitable materials
(cold lamination)
22
Use only laminating foils that meet the
requirements in the Technical Data.
Do not exceed the maximum thickness of
the laminated material and foil.
Laminate the same foil again to improve
the lamination result.
Make sure you do not hot-laminate heat-
sensitive material.
If you use thick laminating foil
(100 μ or 125 μm), let the laminator heat
up for longer.
Hot-roller
230 mm (A 230 Plus), 330 mm (A 330 Plus)
Room temperature: max. 35°C
HOT: 97 - 105°C
230 mm (A 230 Plus), 330 mm (A 330 Plus)
120 (A 230 Plus), 180 (A 330 Plus)
80 - 125 micron
400 mm/min.
Yes
2, Ready and Power
approx. 15 min.
2
220 - 240 V, 50 Hz, 1.3 A (A 230 Plus)
220 - 240 V, 50 Hz, 1.76 A (A 330 Plus)
305 W (A 230 Plus), 405 W (A 330 Plus)
366 x 146 x 66 mm (A 230 Plus)
466 x 146 x 66 mm (A 330 Plus)
approx. 855 g (A 230 Plus),
approx. 1260 g (A 330 Plus)
Non-heat-sensitive material up to a total
thickness of 0.5 mm
Heat-sensitive material up to a total thickness
of 0.5 mm