Olympia A 230 Plus Mode D'emploi page 21

Regular Maintenance and Service
Regular Cleaning
Clean the laminator at regular intervals.
1. Before cleaning, disconnect the plug from the power socket.
2. Use a damp, lint-free cloth to clean the laminator surface.
Removing Adhesive and Other Residues
Adhesive and other residues on the rollers can impair the lamination result.
Remove these at regular intervals and whenever the lamination result is not as
good as expected.
1. Switch the switch to the setting HOT. Wait for about 90 seconds until the lami­
nator has reached optimal operating temperature.
2. Fold a sheet of paper and feed it into the laminator with the folded edge first
and keeping it straight. Residual adhesive is removed and taken up by the
paper when ejected.
3. Repeat the process with a new sheet of paper until the paper comes out clean.
Troubleshooting
The foil jams.
Laminator A 230 Plus / A 330 Plus
Regular Maintenance and Service
Follow the instructions in the section
Clearing Jams.
Use only laminating foils that meet the
requirements in the Technical Data.
Do not exceed the maximum thickness of
the laminated material and foil.
Keep the laminating foil straight when you
feed it into the laminator infeed.
21