Hot Lamination - Olympia A 230 Plus Mode D'emploi

Laminator A 230 Plus / A 330 Plus

Hot Lamination

Hot Lamination
During hot lamination, the laminating foil is heated to a temperature of up to 105°C
as it passes through the laminator rollers. This creates a permanent thermal bond­
ing of the laminated material and the laminating foil. Hot lamination permanently
prevents the laminated material from coming into contact with water, oxygen and
bacteria.
Always exclusively use laminating foil which is suitable for hot lamination.
For an optimum lamination result, we recommend laminating foils from
Olympia Business Systems GmbH, which are available from specialist
retailers.
1. Place the laminator steadily on a level, horizontal surface.
Make sure the on/off switch is switched to OFF before plugging the lamina­
tor into a power socket.
2. Plug the laminator cable into an available power socket.
3. Switch the on/off switch to the setting HOT. The POWER indicator light lights
up.
4. The drive motor for rolling starts up. The optimal operating temperature is
achieved after approx. 90 seconds, and the green READY indicator light lights
up.
5. Place the material to be laminated inside the laminating foil. For an optimal
lamination result, leave an all-round spacing of 3 to 5 mm from the edges of
the foil.
CAUTION!
• Danger of burns due to hot machine surface!
During hot laminating, the machine surface heats up.
Do not touch the machine surface during laminating operation. Wait a few
minutes after laminating until the machine has cooled down before you
touch it.
If the material to be laminated is not in a common DIN format, also place
an insert inside the laminating foil that corresponds with the DIN format of
the laminating foil. Place the material to be laminated at the front edge of
the closed end of the laminating foil.
6. Feed the prepared laminating foil with the closed side first, keeping it straight,
into the infeed of the laminator.
18