Technical Data - Olympia A230 Plus Mode D'emploi

Laminator / 4-in-1 Set A 230 Plus / A330 Plus

Technical Data

The lamination result is not as good
as expected - the laminated pouch
is not completely transparent or is
wavy, or the laminated material is
damaged.
Technical Data
Laminator A230 Plus
Laminating system:
Working width
Laminating temperature
Laminating width (max.)
Warm-up phase
Pouch thickness
Laminating speed:
Automatic switch-off
in case of overheating
Indicator lamps
Cool down phase
Rollers
Power supply
Power consumption
Dimensions
Weight
Suitable materials
(hot lamination)
Suitable materials
(cold lamination)
26
Only use laminating pouches that meet
the requirements in the Technical Data.
Do not exceed the maximum thickness of
the laminated material and pouch.
Laminate the same pouch again to im­
prove the lamination result.
Make sure you do not hot-laminate heat-
sensitive material.
If you use thicker laminating pouches
(100 μm or 125 μm), allow the laminator
to warm up longer.
Hot-roller
230 mm
COLD: max. 25 °C
HOT: 97 - 105 °C
230 mm
Approx. 120 seconds
75 - 125 micron
400 mm/min.
Yes
2, Ready and Power
Approx. 15 min.
2
220 - 240 V, 50 Hz, 1.3 A
300 W
367 x 145 x 70 mm
Approx. 855 g
Non-heat-sensitive material up to a total thick­
ness of 0.5 mm
Heat-sensitive material up to a total thickness
of 0.5 mm