Olympia A230 Plus Mode D'emploi page 19

ATTENTION!
• Material damage!
Avoid exposing the device to environmental influences such as smoke,
dust, vibration, chemicals, moisture, heat or direct sunlight.
Only use the laminator in the ambient conditions permitted under Techni­
cal Data.
Do not laminate metal materials.
Always use cold lamination for heat-sensitive materials.
Never cut unsuitable materials.
Ensure only qualified personnel perform repairs.
Useful Instructions and Tips
The following instructions and tips help you achieve an optimal lamination result
every time and avoid damaging the laminator.
Always disconnect the power plug when the laminator is not in use.
During lamination, ensure sufficient ventilation in the room.
Do not laminate metal, wet or uneven materials.
Always feed laminating pouches into the laminator infeed with the closed side
first and in a straight position.
If necessary, only cut laminating pouches after laminating.
Please remember that hot laminated materials are permanently bonded to the
laminating pouch and cannot be separated from the foil pouch again without
possible damage.
Place the laminator on a level, horizontal surface so that it can discharge the
laminated material without obstruction.
Plug the laminator power cable into an easily accessible power socket.
Do not pull the laminating pouch out of the output side during lamination.
Laminator / 4-in-1 Set A 230 Plus / A330 Plus
Useful Instructions and Tips
19