Olympia A230 Plus Mode D'emploi page 25

Regular Maintenance and Service
Regular Cleaning
Clean the laminator at regular intervals.
1. Before cleaning, disconnect the plug from the power socket.
2. Use a slightly damp, lint-free cloth to clean the laminator surface. Do not use
any solvents or cleaning agents.
Clean the trimmer and corner cutter at regular intervals.
1. Use a slightly damp, lint-free cloth to clean the surfaces of the devices. Do not
use any solvents or cleaning agents.
2. Remove any cut material with a brush.
Removing Adhesive and Other Residues
Adhesive and other residues on the rollers can impair the lamination result. Re­
move these at regular intervals and whenever the lamination result is not as good
as expected.
1. Switch the switch to the setting HOT. Wait for about 120 - 180 seconds until
the laminator has reached its optimal operating temperature.
2. Fold a sheet of paper and feed it into the laminator with the folded edge first
and keeping it straight. Residual adhesive is removed and taken up by the pa­
per when ejected.
3. Repeat the process with a new sheet of paper until the paper comes out clean.
Clearing Errors
The laminating pouch jams.
Laminator / 4-in-1 Set A 230 Plus / A330 Plus
Regular Maintenance and Service
Follow the instructions in the Section
"Clearing Pouch Jams".
Only use laminating pouches that meet
the requirements in the Technical Data.
Do not exceed the maximum thickness of
the laminated material and pouch.
Keep the laminating pouch straight when
you feed it into the laminator infeed.
25